Dryer Fault Codes - Dexter Laundry B Series Operators Manual Installation & Operation Instructions

DRYER CONTROLLER FACTORY DEFAULT PROGRAM SETTINGS
COOL DOWN
DRY
TIME
CYCLE
(MINUTES)
1
2
3
4
5
FAULT
DESCRIPTION
#
F1 thermostat
Open thermostat
F2
EEPROM
F3
corrupted.
Heating element
F4
on fault.
Temperature
F5
8514-265-001 REV C PAGE 19
TOTAL CYCLE
TIME
(MINUTES)
5 35
2 20
5 25
2 20
2 25

DRYER FAULT CODES

FAULT
Dryer stops and "F1" flashes on the 4-digit display.
Shorted
When short circuit on sensor input is removed, "LOAd"
appears on the 4-digit display and the remaining dry
sensor.
Dryer stops and "F2" flashes on the 4-digit display.
When a good sensor is connected to sensor input,
sensor. "LOAd" appears on the 4-digit display and the remaining
Dryer will not start and "F3" appears on the 4-digit
display. The power to the dryer must be cycled to reset
the controller. Fault should only occur when starting a
The drying temperature did not increase 1
minutes. "F4" will flash on the display and the dry cycle
will finish without calling for heat (energizing element
contactor). Opening the door or pressing the STOP key
will reset the fault and clear the remaining time in the
The drying temperature is at least 25
temperature setting. "F5" will flash on the 4-digit display
and the dry cycle will finish without calling for heat
fault.
(energizing the element contactor). The power to the
DRYING
TEMPERATURE
0 0
( F) ( C)
180 82
170 77
180 82
130 54
175 79
ACTION
time is reset.
dry time is reset.
dry cycle.
dry cycle.
dryer must be cycled to reset the controller.
DRYER LOAD
Towels, pads, heavy cotton
Sheets, blended materials
Cotton
Synthetic materials
Blended materials
º
F. in 15
º
F. above the