Dexter Laundry B Series Operators Manual Installation & Operation Instructions page 26

TEMPORARY DRYER CONTROLLER PROGRAMMING EXAMPLE
REQUIREMENTS: Dry a load with 40 minutes of actual heat at 185
The following procedure will show you how to temporarily modify the existing dry cycle 1 program for one
cycle of drying. It is based on the assumption that the factory defaults have not been permanently changed. If
they have been changed, the steps of this procedure will be the same, but the values that are displayed will be
different. The amount of times that the dryer controller touch pad UP or DOWN keys must be pressed and
released may also be different.
If you want the change to be permanent, go to the "PERMANENT DRYER CONTROLLER PROGRAMMING"
section of this manual.
1) After the load has been placed in the dryer, press and release the UP or DOWN touch pad key on
the dryer controller until the L.E.D. for dry cycle 1 is illuminated.
2) Press and release the CYCLE key on the dryer controller touch pad. You will see the number "35" on
the dryer controller display. The programming L.E.D. and dry time L.E.D. will be illuminated.
3) Press and release the UP arrow key on the dryer controller touch pad 10 times so the display will
show a flashing "45". When the UP arrow touch pad key is pressed the first time, the number "36" will be
flashing on the dryer controller display. Each number after that will also flash.
4) Now, press and release the SELECT/ENTER touch pad key on the dryer controller. The number
"45" will stop flashing and the dry time L.E.D. will switch off. The dryer controller display will now show
"180", the temperature L.E.D. will illuminate, and the programming L.E.D. and dry cycle 1 L.E.D. will remain
on.
5) Press and release the UP arrow key on the dryer controller touch pad one time so the controller
display will show a flashing "185". Each press of the UP arrow key will increment the temperature by five
degrees.
6) Now, press and release the SELECT/ENTER touch pad key on the dryer controller. The number
"185" will stop flashing and the temperature L.E.D. will switch off. The dryer control display will now show a
number "5", the cool down L.E.D. will illuminate, and the programming L.E.D. and dry cycle 1 L.E.D. will
remain on.
7) Press and release the SELECT/ENTER key on the dryer controller touch pad, since the desired cool
down time is five minutes. After you press the SELECT/ENTER touch pad key on the controller, the cool
down L.E.D. and programming L.E.D. will switch off. The controller display will remain at "5" and the cycle 1
L.E.D. will remain on.
You are now ready to start the new dry cycle. This new dry cycle will be in effect for one dry cycle only. After
the dry cycle is done, or if the STOP touch pad key on the dryer controller is pressed and released twice,
consecutively, the cycle 1 program will revert to the factory default settings.
If you press the START touch pad key on the dryer controller, the controller display will change from the number
"5" to the number "45" and dry cycle 1 will begin.
PERMANENT DRYER CONTROLLER PROGRAMMING
The permanent programming mode will allow the change of the stored dry cycle settings in the dryer controller
until the operator physically changes them again. The factory default settings can be restored in the dryer
controller by pressing the default settings pushbutton on the back (component) side of the dryer controller circuit
8514-265-001 REV C PAGE 26
º
F and five minutes of cool down.
PROCEDURE