Operating Instructions - Dexter Laundry B Series Operators Manual Installation & Operation Instructions

WARNING: To reduce the risk of fire, electric shock, or injury to persons, read the
IMPORTANT SAFETY INSTRUCTIONS before operating this appliance.
See specifications for the maximum load capacity for dry weight per tumbler
To dry a load of items, you must choose one of the five-programmed dry cycles. Each of these five dry cycles
may be modified in two different ways to match your load. Please refer to the "Permanent Dryer Controller
Programming" or "Temporary Dryer Controller Programming" section of this manual.
There are two parts to each dry cycle. The first part is the heating time, which is when the heating elements
are cycled on and off according to the temperature setting in the dry cycle program. The second part is the cool
down time, which is after the heating part of the dry cycle, and is when the cylinder continues to turn, but no
heat is applied.
There will always be at least two minutes of cool down time for each dry cycle. The maximum amount of cool
down time is 60 minutes.
The default value of the five dry cycles is shown in the "DRYER CONTROLLER FACTORY DEFAULT PROGRAM
SETTINGS" table in this manual.
To improve the drying capabilities of this dryer, you should always separate (untangle) the individual articles in
your load before using the dryer.
In the following instruction steps, things that are displayed on the 4-digit numerical display will be in
"quotation marks" and any keys on the dryer controller touch pad that physically need to be pressed will be in
CAPITAL AND BOLD LETTERS.
1) Place your untangled load into the dryer cylinder and close the dryer loading door. Notice that the dryer
controller 4-digit numerical display should show the word "LOAd". If it does not show this word, then press
and release the STOP touch pad key on the dryer controller twice.
2) Press and release the UP or DOWN arrow touch pad key on the dryer controller to select a dry cycle.
3) Once the desired dry cycle is selected, press and release the START touch pad key.
After the dryer controller START touch pad key is pressed, the dryer cylinder will start rotating and the two-
digit total dry cycle time, along with a decimal point, will appear on the dryer controller display.
The time shown on the dryer controller display will count down to the programmed cool down time. At that
time, the display will change from the decimal point and two-digit number to a letter "C" and two digits.
The letter "C" represents the cool down portion of the dry cycle. The two digits represent the amount of time
remaining in the dry cycle. The two-digit time, shown on the dryer controller display, will count down to
zero.
When the time decrements to zero, the dryer controller display will flash the word "donE" and the end of
cycle tone will sound.
At that point, the wrinkle free cycle will automatically begin. This cycle will wait two minutes, if the door is
not opened or the STOP touch pad key on the dryer controller is not pressed, and then rotate the cylinder
for 10 seconds and stop. This idle time of two minutes and tumble time of 10 seconds will repeat a total of
10 times, at which time the wrinkle free cycle stops. The cylinder will not rotate again until a new dry cycle is
started.
During the wrinkle free cycle the heating elements will not be operated and there will be no heat applied to
the load. The word "donE" will also continue to flash and do so even after the wrinkle free cycle is finished.
When the dryer loading door is opened, or the STOP touch pad key is pressed, the word "donE" will change
to the word "LOAd" on the dryer controller display. The dryer will then be ready for another dry cycle.
8514-265-001 REV C PAGE 23

OPERATING INSTRUCTIONS