Dexter Laundry B Series Operators Manual Installation & Operation Instructions page 22

4-DIGIT NUMERICAL DISPLAY MESSAGES
Message
LOAd
donE
Prog
.15
C02
F5
8514-265-001 REV C PAGE 22
This message is displayed after a dry cycle is complete and
the dryer loading door has been opened or the STOP touch
pad key on the dryer controller has been pressed and
released twice.
This message blinks immediately after completion of the dry
cycle and continues to blink until the stop key on the dryer
controller touch pad is pressed or the dryer loading door is
opened.
This message is displayed when entering the permanent
programming mode.
This message appears while the dryer is in the heating time
of a dry cycle. The decimal point will blink if the output for
the heating elements is on, or remain on constantly if the
output for the heating elements is not on. The number
represents the total time left in the dry cycle (includes cool
down time).
This message appears when the cool down time of the dry
cycle is reached. The letter "C" represents the cool down
(non-heating) part of the dry cycle. The number(s) after the
letter "C" represent(s) the total time remaining in the dry
cycle.
This message appears if there is a dryer fault. The letter "F"
indicates a fault and the number after the "F" represents the
specific fault that has occurred. There are five different
faults that can appear (F1 through F5).
Description