2400Ejf, 3400Ejf, 4400Ejf Nozzle Options - Kasco 3400EVFX Owner's Manual

Tighten until snug with a Phillips Head screw driver
and repeat for 3 remaining screws.
STEP FOUR
Turn secured assembly upside down so the top of the
fl oat (logo side) is face down on the fl at surface. Place
Bottom Screen (Part 10) onto the bottom side of the
fl oat. Make sure the wide opening of the screen is
against the fl oat and the 3 handles on the screen do not
interfere with the rope placements. Fit the 3 Bottom
Screen cushion (Part 9) underneath the screen and on
top of the 3 spacing bumps on the bottom of the fl oat.
Bottom Screen cushion
STEP FIVE
Using a stainless steel Bottom Screen Clip (Part 11),
3/8"-16 x 1-3/8" Bolt (Part 6), two 3/8" Flat Washer
(Part 7), and 3/8"-16 Nylon Lock Nut (Part 12) to
secure the screen to the fl oat. Align a clip so the two
prongs straddle a wire on the screen. Insert bolt with
washer so the top of the bolt is facing the top of fl oat
(now in down position). Place the second washer and
the locking nut with nylon insert on the end of the bolt
and tighten using the 9/16" (14mm) Socket and Ratch-
et on the nut end and the 9/16" (14mm) Wrench on the
bolt end. Tighten until snug and repeat with remaining
clip.
8
2400EJF, 3400EJF, 4400EJF
Nozzle Options
NOTE: Pattern sizes listed are approximate.
Variations in voltage caused by regional electrical dif-
ferences or voltage drop due to long power cords may
result in reduced pattern sizes.
• The Cypress is the only nozzle that uses the sepa-
rate collar labeled C2.
• The Cypress, Linden, Willow, and Juniper nozzles
use the 3/8" x 4" bolt.
• The Sequoia nozzle uses the shorter 3/8" x 2.25"
bolt.
To install, simply drop the bolt through the nozzle and
thread into the top of the cone on the fountain.
Cypress Display: The Cypress nozzle (marked C1
on fi n) makes use of the collar (marked C2 on the top
rim) and the 3/8" x 4" bolt.
Model Height
2400EJF 1.3 m
3400EJF 1.8 m
4400EJF
Width
2.8 m
5.3 m
n/a n/a