2400Evfx 3400Evfx 4400Evfx; 2400Ejf 3400Ejf 4400Ejf; Important Safety Instructions; Unit Specs - Kasco 3400EVFX Owner's Manual

CAUTION
NOTICE (NOTE)
These international safety symbols are used
throughout this manual to inform the owner of
important safety information and notices for
safe and effective use of the equipment.

Important Safety Instructions

CAUTION
• Under NO circumstances should anyone enter
the water with the electrical equipment con-
nected and/or in operation. It is NEVER rec-
ommended to enter the water with the equip-
ment in operation.
• Caution should be used when dealing with any
electrical equipment with moving parts.
• NEVER run the unit out of water. It will dam-
age the seals and create a dangerous situation
for the operator.
• Extreme caution should be used around water,
especially cold water, such as in Spring, Fall,
and Winter, which poses a hazard in and of
itself.
• NEVER lift or drag the unit by the power or
light cord. If you need to pull the unit to the
side of the pond, use the anchoring ropes.
• Do not use waders in deep ponds/lakes or
ponds/lakes with drop-offs, drastic slopes, or
soft bottom material.
• Do not use boats that tip easily for fountain
installation, such as a canoe, and follow all
boating safety rules and regulations, including
wearing a PFD. (Personal Flotation Device)
• The unit is supplied with an internal ground-
ing conductor. To reduce the risk of electrical
shock, be certain that the unit is plugged/con-
nected to an approved RCD (GFCI) protected
circuit.
• Means for disconnection must be incorporated
in the fi xed wiring in accordance with local and
national wiring rules.
• Consult a qualifi ed electrician for electrical
installation.
2

Unit Specs

Model Voltage Operating
2400EVFX 208-240
3400EVFX 208-240
4400EVFX 208-240
2400EJF 208-240
3400EJF 208-240
4400EJF 208-240

Quick Disconnect Installation

Important – Read Carefully Before Installation
Before using the connector, it is important that these
instructions are carefully read and understood to
ensure the connector system is completely water tight
and electrically safe.
IF IN DOUBT CONSULT A QUALIFIED ELECTRI-
CIAN.
The socket (female) insert of the connector must be
the live part of the connector from the supply. The pin
(male) insert of the connector must lead to the load or
electrical device. On 50Hz units, the pin (male) insert
of the connector is installed at the factory. To ensure
effi cient sealing, use only smooth circular cable.
Pin Insert (Installed on Stub Cord)
Main Body
Pin Insert
Socket Insert (User Installed)
Socket insert
Main Body
lock rotor
amps amps
2.2@240V 6@240V
3.6@240V 9@240V
5.9@240V 20@240V
2.2@240V 6@240V
3.8@240V 9@240V
6.5@240V 20@240V
Gland
Gland Nut
Gland
Gland Nut