TABLE OF CONTENTS Safety First �������������������������������������������������������������������������������������������������������������������������������2 Unit Specifications �����������������������������������������������������������������������������������������������������������������2 Parts Included �������������������������������������������������������������������������������������������������������������������������3 Installation Instructions ���������������������������������������������������������������������������������������������������������5 Maintenance Recommendations ������������������������������������������������������������������������������������������6 Troubleshooting Tips ��������������������������������������������������������������������������������������������������������������7 Warranty ����������������������������������������������������������������������������������������������������������������������������������8 Other Repairs ��������������������������������������������������������������������������������������������������������������������������9 Repair Contact Form ������������������������������������������������������������������������������������������������������������10 TOOLS AND SUPPLIES NEEDED • 7/16” socket and ratchet • 7/16”...
Back to Contents INSTALLATION INSTRUCTIONS Attach the strain relief to the line closest to the cord. Correct anchoring Incorrect anchoring Mooring lines are too short or loose between Mooring lines are proper length and taut unit and anchors. between unit and anchors (at least 3 feet from the float for every foot of water depth).
Sacrificial Anode All Kasco units include a sacrificial anode installed on the shaft to protect against corrosion and electrolysis. Replace the anode if it is reduced to half the original size or if it is white in color. Corrosion from electrolysis most commonly occurs in saltwater or brackish water, but it is important to check the anode in all installations at least every two to three months.
Back to Contents TROUBLESHOOTING TIPS ALWAYS DISCONNECT EQUIPMENT FROM ELECTRICAL SOURCE BEFORE SERVICING SERVICE SHOULD ONLY BE PERFORMED BY A QUALIFIED TECHNICIAN OR ELECTRICIAN Ground fault/earth leakage protection (RCD) tripping Typically indicates electrical current is leaking to earth (ground). • Consult a qualified service technician or electrician to address the issue.
Also, register the unit online at: www.kascomarine.com. Once the warranty coverage has been established, the unit may be sent to any Kasco authorized repair center for evaluation and repair. Please call Kasco at 715-262-4488 prior to shipping to receive any updated information or a repair form, or call to locate your nearest authorized repair center.
Please ship according to the instructions in the previous section. Kasco does estimates on repairs at the request of the customer. The request for an estimate should be included in the letter that accompanies the returned unit and must include a daytime phone number and/or email address.
Back to Contents REPAIR CONTACT FORM • Kasco requires that all equipment sent for repair MUST be accompanied by this form and marked to Repairs attention. Kasco Marine • Unit should be cleaned before shipping. 800 Deere Road • Kasco is NOT responsible for shipping damage accrued in Prescott, WI 54021 return shipment.