Power Settings Menu - Eiki EK-812U Owner's Manual

I
tem
Hot-Key settings
Power Settings
Light Source Settings
Information
Factory Reset
Service

Power Settings Menu

Press the Menu button to open the OSD menu. Press the arrow keys (pq) to select OPTION and press
the Enter button to enter the OPTION menu. Press the arrow keys (pq) to select Power Settings and
press the Enter button to enter the Power Settings menu. Press the arrow keys (pq) to select the menu
option and press the Enter button to enter its submenu. Press the arrow keys (pqtu) to select or adjust
the desired settings and press the Enter button to confirm.
PICTURE
I
tem
Standby Power Mode
Direct Power On
Signal Power On
Assign Aspect Ratio or Freeze Screen as a hot-key on the remote control
by highlighting the desired function in the list and pressing the Enter button.
Choose a function that does not already have a dedicated button, and
assign the hot-key to that function, allowing you to quickly and easily use
either of the chosen functions.
Configure the power settings. See "Power Settings Menu" on page 43.
Configure the light source settings. See "Light Source Settings Menu" on
page 44.
Display various projector related information on the screen.
Restore all settings to their default value. It will not reset network.
WARNING: After resetting, lens calibration is necessary.
For service only.
Standby Power Mode
Direct Power On
OUTPUT
Signal Power On
Auto Power Off (min.)
Sleep Timer (min.)
SETUP
OPTION
Set the standby power mode.
• 0.5W mode: The projector is in standby mode when connected to AC
power. (<0.5W)
• Active mode: Low power consumption (< 2 Watt) which allows the LAN
module to enter sleep mode and supports to be woken by Wake on LAN
(WoL). When the LAN module is woken by WoL, the projector is ready to
receive commands over the network.
• Communication mode: The projector could be controlled via the LAN
terminal during power standby.
The projector automatically turns on when electrical power is connected.
Choose On to activate Signal Power On. The projector will automatically
turn on after detecting HDMI input source. The available options inlcude On
and Off.
DLP Projector — Owner's Manual
D
escrIptIon
Power Settings
Communication Mode
D
escrIptIon
43
— —
Off
Off
20
0