Table of Contents
Advertisement
DLP Projector — Owner's Manual
Remote Control Operating Range
The remote control uses infrared transmission to control the projector. It is not necessary to point the
remote directly at the projector. Provided you are not holding the remote perpendicular to the sides or
the rear of the projector, the remote will function well within a radius of about 7 meters (23 feet) and 15
degrees above or below the projector level. If the projector does not respond to the remote control, move
a little closer.
Projector and Remote Control Buttons
The projector can be operated using the remote control or the buttons on the rear of the projector. All
operations can be carried out with the remote control; however, the buttons on the projector are limited in
use.
Remote Control Code
The ten different remote control modes (Code 0- Code 9) are assigned to this projector. Switching the
remote control codes prevents interference from other remote controls when several projectors or video
equipment next to each other are being operated at the same time. Change the remote control code for
the projector first before changing that for the remote control. See "Communications menu" on page 42.
To change the code for the Remote Control:
Press and hold the Mode button and a number button (0-9) on the remote control for more than three
seconds to switch among the codes.
Default setting: 0
To change the Projector Address for the projector:
Select a Projector Address in the Setup Menu. (SETUP → Communications → Projector Address)
8
—
—
Advertisement
Table of Contents
