Instruction manual Primus 25 advanced®
6.2 Sample program
Select MODE, then PROGRAM and create a new program with NEW. Enter a program name and con-
firm with Enter to access the programming functions.
01
LIDHT
Press Enter to insert a new program step. Move from each parameter to the next with the cursor keys
() or with Enter.
02
TEMP
Enter another program step with Enter. Choose one of the steps listed above by using the () cursor
keys, e.g., LOOP[.
03
LOOP[
Continue by entering a temperature profile.
04
TEMP
05
TEMP
06
TEMP
End the cycling step with LOOP] and with the next step switch the heated lid off.
07
LOOP]
08
LIDHT
Ramps may be inserted into any program. The ramp starts from the last programmed temperature (here
72 °C) and decreases temperature to the set temperature (here 8 °C) at a constant rate.
09
RAMP
10
STORE
11
End
PEQLAB_v0314_E
ON
120 °C
94.0 °C
+0.0 °C
0:02:00 +0:00
30x
94.0 °C
+0.0 °C
0:00:30 +0:00
50.0 °C
-0.5 °C
0:00:30 +0:00
72.0 °C
+0.0 °C
0:00:30 +0:05
OFF
4.0 °C
1.0 °C/s
8.0°C
+0.0°C
Forever
+0.00
Heated lid on, temperature 120 °C
Denaturation at 94 °C
For 2 minutes
Open a program loop - 30 cycles
Denaturation at 94°C
For 30 seconds
(Press 0 to enter the time in seconds)
Annealing at 50°C with stepwise
temperature decrement by 0.5 °C (Touch-
down)
Elongation with stepwise time increment
by 5 seconds
End the program loop
Lid heat off
Target temperature 8 °C with
a speed of 1 °C per second
Final temperature 8 °C
(Minus key!)
End of program
7