Messages, Warnings And Failure Codes - Barco Graphics 808s Owner's Manual

8

MESSAGES, WARNINGS AND FAILURE CODES

SOURCE 01
Fh= 15.6 kHz
Fv= 050 Hz
SOURCE 01
Fh= 15.6 kHz
Fv= 050 Hz
enter
password
xxxx
text on
text off
PROJECTOR
ADDRESS :
003
WARNING :
input not
available
5976283 BARCORAPHICS 808s 160501
All manuals and user guides at all-guides.com
When selecting a new source,
information about this source
will be displayed on the screen.
Source number, horizontal and
vertical frequencies of the dis-
played source.
Announcement of the selected
source.
Message to enter your pass-
word. Password contains 4
digits.
These messages will be dis-
played on the screen when push-
ing the <TEXT> key.
Text ON : the 'bar scale indica-
tion' will be enabled during the
change of an analog control in
the 'operational mode' + all warn-
ings and failures will be dis-
played.
Text OFF : the 'bar scale indica-
tion' will be disabled during the
change of an analog control in
the 'operational mode' + all warn-
ings and failures will not be dis-
played.
Indication of the projector ad-
dress when activating the 'AD-
DRESS' button on the RCU with
a pencil or other small object.
When using the projector with
the RCVDS, this warning will be
displayed when selecting an in-
put slot of an RCVDS where the
input board is missing.
Messages, warnings and failure codes
The input is a valid input but the
WARNING :
source is not connected to the
input terminals or the input source
source not
is switched off.
available
WARNING :
When a wrong key is pressed on
invalid
the RCU.
key entry
WARNING :
Message when the entered
password is wrong.
invalid
code entry
WARNING :
End of adjustment range.
end of ad-
just range
Message will be displayed when
WARNING :
the input source is no longer
input no
available. The following message
longer
then appears: 'check input sig-
available
nal or select new source' .
This message will be displayed
after the message 'input no
check input signal
longer available'. It asks to check
or select
the connections between the
new source
source and the projector or to
check if the source is switched
on.
It warns you to check the power
WARNING :
connection or the power status
input selector
of the RCVDS.
not
Next message will appear imme-
available
diately on the screen : 'go to
stand-by' .
8-1