Peripheral Equipment - Barco Graphics 808s Owner's Manual

PERIPHERAL EQUIPMENT

Connecting a RCVDS 05 switcher to the
retroprojector.
- Up to 20 inputs with the RCVDS 05 switcher and up to 90 inputs
when 10 RCVDS switchers are linked via the 5-cable input modules.
- Serial communication with the projector.
- Remote control buttons on the RCVDS to control the
retroprojector (source selection and analog settings)
- The selected source number will be displayed on a 2 digit display
and the selected input modules will be indicated with a LED on the
rear.
For more information consult the Owner's Manual of the RCVDS.
Connecting a VS05 switcher to the retroprojector.
The VS05 can switch up to 5 Composite Video sources, 3 S-Video
Sources and 1 RGB analog or component Video source to the
retroprojector. In addition, an audio signal associated with the
source, can be switched to an audio amplifier.
Order number : R9827890.
For more information consult the Owner's Manual.
Connecting an IR Remote Receiver to the
Projector.
This infrared receiver unit makes it possible to control the projector
from another room. There is a communication line cable between the
IR receiver and the projector or the RCVDS. The infrared control
information from the Remote Control Unit is sent to the IR Remote
Receiver. The IR Remote Receiver 800 displays the selected source
on a 7-segment display.
5976283 BARCOGRAPHICS 808s 160403
All manuals and user guides at all-guides.com
Connections
3-5