Messages, Warnings And Failures - Barco R9040014 Installation Manual

8

MESSAGES, WARNINGS AND FAILURES

INPUT 01
RGB2
Fh= 15.6 kHz
Fv= 050 Hz
SOURCE 01
RGB2
enter
password
x x x x
TEXT on
SOURCE 01
RGB2
xxxkHz
xxHz
TEXT off
PROJECTOR
ADDRESS :
003
WARNING :
input not
available
WARNING :
source not
available
WARNING :
invalid
key entry
5976257 BARCOREALITY 909 16032001
When selecting a new source,
information about this source will
be displayed on the screen. Source
number, horizontal and vertical fre-
quencies of the displayed source.
Announcement of the selected
source.
Message to enter your password.
Password contains 4 digits.
These messages will be displayed
on the screen when pushing the
TEXT key.
Text ON : the 'bar scale indication'
will be enabled during the change
of an analog control in the 'opera-
tional mode' + all warnings and
failures will be displayed.
Text OFF : the 'bar scale indication'
will be disabled during the change
of an analog control in the 'opera-
tional mode' + all warnings and
failures will not be displayed.
Indication of the projector address
when activating the 'ADDRESS'
button on the RCU with a pencil or
other small object.
When using the projector with the
RCVDS, this warning will be dis-
played when selecting an input
slot of an RCVDS where the input
board is missing.
The input is a valid input but the
source is not connected to the
input terminals or the input source
is switched off.
When a wrong key is pressed on
the RCU.
Messages, warnings and failures
WRONG
PASSWORD
!!!
WARNING :
end of ad-
just range
WARNING :
input
no longer
available
WARNING :
RCVDS not
available
WARNING :
invalid
frequency
input
WARNING :
permanent
BOOST mode in
use !!!
WARNING :
Option not
installed !
FAILURE
I2C error
addr. : 7FH3
FAILURE
short
circuit on
I2C bus
Message when the entered pass-
word is wrong.
End of adjustment range.
The input source is no longer avail-
able.
The input source selector is not
available.
The entered frequency or applied
frequency of the source is out of
the projector's range.
The CRT drive mode is switched to
permanent boost.
Option not installed. e.g. Video
selected but no decoder installed.
Hardware failure. Call a qualified
service technician for repair.
Hardware failure. Call a qualified
service technician for repair.
8-1