Deletion Of Blocks; Deleting Block By Block; Deletion Of All Blocks - Barco Graphics 808s Owner's Manual

Deletion of blocks

This item is password protected.
The delete function is used to clear all data (settings) from an
adjustment block.
A delete can be given :
- Block by block
or
- For all blocks.

Deleting block by block

The delete a block function deletes the settings of a selected block.
Highlight 'Delete a block' with the control disc and press ENTER.
Push the control disc é or ê to select the desired adjustment block.
Press ENTER to delete the selected adjustment block. A confirmation
menu will be displayed.
ENTER will delete the selected block.
EXIT cancels the deletion procedure and returns to the Service mode
main menu.

Deletion of all blocks

Highlight 'delete all blocks' with the control disc and press ENTER.
ENTER gives a confirmation message before deleting.
If you are certain you wish to delete all blocks, press ENTER to
confirm, otherwise press EXIT to return.
Once ENTER is pressed, all block headers and adjustment settings
are permanently removed and cannot be restored.
5976283 BARCOGRAPHICS 808s 160501
All manuals and user guides at all-guides.com
SERVICE MODE
IDENTIFICATION
COPY A BLOCK
DELETE A BLOCK
DELETE ALL BLOCKS
CHANGE PASSWORD
CHANGE LANGUAGE
RUN TIME
SET TO MIDPOSITION
CONVERGENCE MID
DYNAMIC ASTIGMATISM
MORE...
Select with or
then <ENTER>
<EXIT> to return.
DELETE MODE
Nr. Src Fh Fv inp conf
1 1 15.6 50 video FC
2 3 31.2 60 RGB3S R T
3 - 15.6 50 intern FC
4 2 31.5 50 RGB3S FC
5 - 33.7 60 intern FC
6
7
8
Active block nr.
1
Select with or
<ENTER> to copy
<EXIT> to return.
DELETE BLOCK
The selected block
will be deleted !
<ENTER> to confirm
<EXIT> to cancel
SERVICE MODE
IDENTIFICATION
COPY A BLOCK
DELETE A BLOCK
DELETE ALL BLOCKS
CHANGE PASSWORD
CHANGE LANGUAGE
RUN TIME
SET TO MIDPOSITION
CONVERGENCE MID
DYNAMIC ASTIGMATISM
MORE...
Select with or
then <ENTER>
<EXIT> to return.
DELETE BLOCK
All block
will be deleted !
<ENTER> to confirm
<EXIT> to cancel
Service Mode
7-3