Controlling Chained Projectors - Barco Graphics 808s Owner's Manual

Controlling
The bar scale increases when pressing on the + button (higher
brightness) and decreases when pressing on the - button (lower
brightness).
Contrast Control
A correct 'contrast' setting is important for good image reproduction.
Adjust the contrast to the level you prefer, according to room lighting
conditions. If the Contrast Control is too low, the picture will be too
dim. If it is set too high, the picture may be too bright and not sharp.
A bar scale gives a visual indication on the screen of the current
contrast setting while pressing the + or - buttons (RCU). If the bar
scale is not visible on the screen, press 'TEXT' key once and retry
the above indicated keys.
The bar scale increases when pressing on the + button (higher
contrast) and decreases when pressing on the - button (lower
contrast).
Color Saturation Control
Color saturation is only active for Video and S-Video Inputs. This
control adjusts the color intensity of the picture. Adjust the color
saturation using the + and - buttons (RCU). A bar scale gives a visual
indication on the screen of the current color setting while pressing
on the above indicated keys. If the bar scale is not visible on the
screen, press 'TEXT' key once and retry the above indicated keys.
The bar scale increases when pressing on the + button (richer
colors) and decreases when pressing the - button (lighter colors).
Tint Control
Tint is only active for Video and S-Video Inputs. The Tint Control is
effective only when using the NTSC 4.43 or NTSC 3.58 system. A
bar scale gives a visual indication on the screen of the current tint
setting while pressing the + or - buttons (RCU). If the bar scale is not
visible on the screen, press the 'TEXT' key once and retry the above
indicated buttons.
The bar scale increases when pressing on the + button (greener
flesh tones) and decreases when pressing the - button (redder flesh
tones).
4-4
All manuals and user guides at all-guides.com
Sharpness Control.
Sharpness control is only active for Video and S-Video Inputs. A bar
scale gives a visual indication on the screen of the current sharpness
setting while pressing the + or - buttons (RCU). If the bar scale is not
visible on the screen, press 'TEXT' key once and retry the above
indicated keys.
The bar scale increases when pressing on the + button (sharper
picture) and decreases when pressing on the - button (softer
picture).

Controlling chained projectors.

Projectors can be controlled individually as well as in a group.
For individual control see previous pages.
For group control of the projectors.
(Input selection and analog picture control)
Program the 'zero address' into any RCU. Therefore, press on the
address key and key in the address ("0") with the numeric keys on
the RCU itself.
Once address '0' is pressed, all projectors will be controlled together
until a new address is entered on the RCU. It is possible to have a
common input selection and a common analog picture control.
Once a new address is entered, only the projector with that specific
address will follow the new instructions.
Note : For group control, all projectors in a control group must be
capable of receiving the IR signal from the controlling RCU at the same
time.
5976283 BARCOGRAPHICS 808s 160501