Controlling; Battery Installation In The Rcu - Barco Graphics 808s Owner's Manual

Hide thumbs Also See for Graphics 808s:

Table of Contents

CONTROLLING

Caution : Do not display a stationary image with full brightness

and contrast for longer than 20 min., otherwise you risk damage to

the CRT's.

A new battery (not yet installed to save the battery life) is delivered inside the plastic bag with the

power cord. Before using the RCU, follow the battery installation procedure.

Remove the battery cover on the backside of the RCU by pushing the indicated handle a little to the

bottom of the RCU. Lift up the top side of the cover at the same time (fig. 1).

Insert the new 9 V battery (type 6F22S or equivalent) in the lower compartment and connect the

battery to the contact plate.

Insert the battery into the lower compartment and put the cover back.

5976283 BARCOGRAPHICS 808s 160501

All manuals and user guides at all-guides.com

Contact

plate

Battery

310a.DRW

Behind the

plastic cover,

insert the 'card

for RCU'. You

can cut out the

insert card on

the last page of

the installation

manual.

fig.2

Controlling

fig.1

4-1

Table of Contents