Location And Functions Of Control; Rear Panel Terminology - Barco Graphics 808s Owner's Manual

2
LOCATION AND FUNCTION OF CONTROLS

REAR PANEL TERMINOLOGY

S e e in s ta lla tio n in s tru c tio n s b e fo re c o n n e c tin g to th e s u p p ly .
V o ir la n o tic e d 'in s ta lla tio n a va n t d e ra c c o rd e r a u rØ s e a u .
120/230 V
V-nom 800 peripherals
I-nom 7/5 A mp
OFF ON 50/60 Hz
Freq
P O W E R / MAIN S C O MM. P O R T P O R T 3
1 2 3 4
1 AC Power Switch : to switch on the projector.
Depending on the set-up of the projector during installation, the projector switches to standby or to 'Operational mode. If in standby,
the standby LED lights up.
2 AC Power Input : connect the supplied AC power (mains) cord here and to the wall outlet.
3 Communication Port (800 peripherals)
* Allows communication between the RCVDS switcher and the projector.
* Allows connection of a remote IR receiver unit to the projector.
4 Port 3
RGB Analog Input (9 pin female sub D connector). Allows a character generator, microcomputer, etc. having analog RGB outputs
to be connected to the projector.
5 Port 4/5 : RGB-S Input (5x BNC connector):
RGB-S input : allows a character generator, microcomputer, video camera, etc. having analog RGB output to be connected to the
projector.
Line inputs: - Signals RED-GREEN-BLUE
- COMPOSITE sync. signal
- Tri level sync signal (option)
6 DEFOCUS: For future expansion
7 75 ohm Termination Switch for S- Video signals
8 X-POS / Y-POS: For future expansion
9 75 ohm Termination Switch forVideo signals
10 IR Remote
Connector for remote input for hard wired remote control
11 Projector Pilot Lamp : Indicates the status of the projector.
- Unlit : mains (power) switch is not pressed.
- Lit : mains (power) switch is pressed and the indicated color shows the projector mode:
Green color : operational mode of the projector.
Red color : standby mode of the projector.
Important : projector ("Operational" or "Standby") mode is defined during the installation of the projector. (Refer to a qualified
technician for change).
12 IR Sensor
Receiver for control signals transmitted from the RCU.
13 RS 232 Output Port
RS 232 Input Port allows a communication link for PC or MAC to the next projector in a series of projector.
14 RS 232 Input Port
Connection between the projector and an IBM PC (or compatible) or MAC (RS422) for remote computer control and data communication.
5976283 BARCOGRAPHICS 808s 160403
All manuals and user guides at all-guides.com
R G B
Comp-/H-Sync V-Sync DEFOCUS OFF - ON X-POS
75 O hm
PORT 4/5 PORT 2
5 6 7

Location and Functions of Control

This dev ice complies with part 15 of
the FCC rules. Operation is subj ect to
fo l l o w i n g tw o c o n d i ti o n s (1 ). Th i s
dev ice may not cause harmful inter-
ference, and (2) this dev ice must
accept any interference receiv ed
including interference that may cause
undesired operation"
green : operation
Y-POS OFF - ON
75 O hm red : standby
P O R T 1
PROJECTOR MODE
9 10
8
2-1