Messages, Warnings And Failures; Messages; Warnings - Barco BARCOREALITY 908 Installation Manual

8. MESSAGES, WARNINGS AND FAILURES

Overview
•

Messages

•

Warnings

• Failures
8.1 Messages
Messages
INPUT 01 RGB2 Fh=064kHz Fv=060Hz
SOURCE 01 RGB2
enter password XXXX
WRONG PASSWORD !!!
TEXT on SOURCE 01 RGB2 xxxkHz xxHz
TEXT On
TEXT Off
PROJECTOR ADDRESS: 003
8.2 Warnings
Warnings
WARNING: Input not available
WARNING: Source not available
WARNING: Invalid key intro
WARNING: End of adjust range
WARNING: Input no longer available
WARNING: RCVDS not available
WARNING: invalid frequency input
WARNING: permanent BOOST mode in
use !!!
WARNING: Option not installed !
R5976354 BARCOREALITY 908 SPLIT PACK 10092002
When selecting a new source, following information about this source
will be displayed on the screen: Source number, horizontal and
vertical frequencies of the displayed source.
Announcement of the selected source.
Message to enter your password, password contains 4 digits.
Message when the entered password is wrong
These messages will be displayed on the screen when pushing the
TEXT key.
TEXT On: the 'bar scale indication' will be enabled during the change
of an analog control in the 'operational mode' + all warnings and
failures will be displayed.
Text OF: the 'bar scale indication' will be disabled during the change
of an analog control in the 'operational mode' + all warnings and
failures will not be displayed.
Indication of the projector address when activating the 'ADDRESS'
button on the RCU with a pencil or other small object.
When using the projector with the RCVDS, this warning will be displayed when
selecting an input slot of an RCVDS where the input board is missing.
The input is a valid input but the source is not connected to the input terminals or
the input source is switched off.
When a wrong key is pressed on the RCU.
End of adjustment range.
The input source is no longer available.
The input source selector is not available.
The entered frequency or applied frequency of the source is out of the projector's
range.
The CRT drive mode is switched to permanent boost.
Option not installed. e.g. Video selected but no decoder installed.
8. Messages, Warnings and Failures
57