Huawei UPS5000-S-600 User Manual page 209

UPS5000-S-600 kVA
User Manual (Three-phase, Three-wire)
Alarm ID Alarm Name
(Alarm
ID-Cause
ID)
0341 PDC Maint. breaker
closed
0342 Mains input breaker
open
0343 BPM input breaker
open
0340 Maint. breaker
closed
0335 Generator
connected
Insufficient
0594-1
redundant racks
0095-1 Insuffi. redundancy
0096-1 ECO volt.
Abnormal
Issue 05 (2019-12-20)
Severity Cause
is OFF.
Minor The maintenance
circuit breaker on
the PDC is ON.
Critical The mains input
circuit breaker is
OFF.
Critical The bypass input
circuit breaker is
OFF.
Minor The maintenance
circuit breaker is
ON.
Warning The generator is
connected.
 The load is
Minor
excessive.
 The configured
number of
redundant racks
is incorrect.
Minor  The load is
excessive.

The configured
number of
redundant
modules is
incorrect.
Minor  The ECO bypass
voltage or
frequency is out
of the preset
range.

The ECO bypass
voltage or
frequency range
is incorrectly set.
 The bypass input
sequence is
reverse or the
Copyright © Huawei Technologies Co., Ltd.
A Alarm List
Solution
output breaker open alarm
has disappeared. If the alarm
persists, tap the Clear Fault
button to clear the alarm.
The running status is displayed.
No further measures are required.
The running status is displayed.
No further measures are required.
The running status is displayed.
No further measures are required.
The running status is displayed.
No further measures are required.
The running status is displayed.
No further measures are required.
1. Reduce the load.
2. Decrease the configured
number of redundant racks.
1. Reduce the load.
2. Decrease the configured
number of redundant modules.
1. Check the bypass input voltage
and frequency.
2. Check that the rated voltage,
rated frequency, ECO bypass
voltage range, and frequency
range are correctly set.
3. Check that the bypass cables
and circuit breakers are
correctly connected.
201