Removing The Power Connectors; Prerequisites; Procedure - Dell 5000 Service Manual

NOTE: Before working inside your Embedded Box PC, read the safety information that shipped with your Embedded Box
PC and follow the steps in
follow the steps in After working inside your Embedded Box
Compliance home page at www.dell.com/regulatory_compliance.
Topics:
•

Prerequisites

•

Procedure

Prerequisites
1. Follow step 1 to step 6 in "Removing the back
2. Remove the PCI/PCIe card
3. Remove the heat sink.
Procedure
1. Remove the nut and washer that secure the barrel connector to the chassis.
2. Push the barrel connector through the slot chassis.
3. Remove the screw that secures the grounding cable to the system board.
4. Disconnect the power cable from the system board.
5. Remove the power cable from the routing guide on the system board

Removing the power connectors

Before working inside your Embedded Box
cover".
(if installed).
PC. After working inside your Embedded Box PC,
PC. For more safety best practices, see the Regulatory
Removing the power connectors
45
77