NOTE:
Before working inside your Embedded Box PC, read the safety information that shipped with your Embedded Box
PC and follow the steps in
follow the steps in
After working inside your Embedded Box
Compliance home page at www.dell.com/regulatory_compliance.
Topics:
•
Procedure
•
Post-requisites
Procedure
1. Connect the serial-port cable to the connector on the system board.
2. Insert the serial ports into the respective slots on the bottom cover.
NOTE:
Match the port number with the number on the cable.
3. Replace the hexagonal screws that secure the serial ports to the bottom-cover.
Post-requisites
1. Replace the
PCI/PCIe card
2. Follow step 2 to step 8 in
"Replacing the back
Before working inside your Embedded Box
(if necessary).
cover".
Replacing the serial ports
PC. After working inside your Embedded Box PC,
PC. For more safety best practices, see the Regulatory
38
Replacing the serial ports
67