Replacing The Solid-State Drive In To Bracket; Procedure; Post-Requisites - Dell 5000 Service Manual

Replacing the solid-state drive in to bracket

NOTE: Before working inside your Embedded Box PC, read the safety information that shipped with your Embedded Box
PC and follow the steps in
follow the steps in After working inside your Embedded Box
Compliance home page at www.dell.com/regulatory_compliance.
CAUTION: Solid-state drives are fragile. Exercise care when handling the solid-state drive.
Topics:
•

Procedure

•

Post-requisites

Procedure
1. Align the notch on the solid-state drive with the tab on the solid-state drive slot.
2. Slide the solid-state drive firmly into the slot and align the screw hole on the solid-state drive with the screw hole on the solid-state
drive bracket
3. Replace the screw that secures the solid-state drive to the solid-state drive bracket.
Post-requisites
1. Replace the drives in to the hard-drive
2. Follow step 2 to step 8 in "Replacing the back
Before working inside your Embedded Box
cage.
cover".
PC. After working inside your Embedded Box PC,
PC. For more safety best practices, see the Regulatory
Replacing the solid-state drive in to bracket
11
23