Removing the WWAN-antenna connectors
NOTE:
Before working inside your Embedded Box PC, read the safety information that shipped with your Embedded Box
PC and follow the steps in
follow the steps in
After working inside your Embedded Box
Compliance home page at www.dell.com/regulatory_compliance.
Topics:
•
Prerequisites
•
Procedure
Prerequisites
1. Follow step 1 to step 6 in
"Removing the back
2. Remove the
PCI/PCIe card
Procedure
1. Remove the nuts and washers that secure the WWAN-antenna connectors one and two to the chassis.
2. Push the WWAN-antenna connectors through the chassis.
a. chassis
b. WWAN-antenna connector two
c. WWAN-antenna connector one
3. Disconnect the antenna cables from the WWAN card.
4. Remove the WWAN-antenna cables from the WWAN-cable routing guides on the chassis.
5. Remove the WLAN-antenna cable off the chassis.
Before working inside your Embedded Box
cover".
(if installed).
PC. After working inside your Embedded Box PC,
PC. For more safety best practices, see the Regulatory
Removing the WWAN-antenna connectors
23
43