Removing The Top Cover; Prerequisites; Procedure - Dell 5000 Service Manual

NOTE: Before working inside your Embedded Box PC, read the safety information that shipped with your Embedded Box
PC and follow the steps in
follow the steps in After working inside your Embedded Box
Compliance home page at www.dell.com/regulatory_compliance.
Topics:
•

Prerequisites

•

Procedure

Prerequisites
1. Follow step 1 to step 6 in "Removing the back
2. Remove the PCI/PCIe card
3. Remove the CANbus cable.
4. Remove the riser card.
5. Remove the power connectors.
Procedure
1. Disconnect the power-switch cable and remove it from the routing guides on the chassis.
2. Remove the hexagonal screws that secure the VGA port to the top cover.
1. #4 40UNCx6.3 hexagonal screws (2)
3. routing guides (4)
5. chassis
3. Remove the screws that secure the top cover to the chassis.
80

Removing the top cover

Before working inside your Embedded Box
cover".
(if installed).
Removing the top cover
PC. After working inside your Embedded Box PC,
PC. For more safety best practices, see the Regulatory
2. VGA port
4. power-connector cable
47