NOTE:
Before working inside your Embedded Box PC, read the safety information that shipped with your Embedded Box
PC and follow the steps in
follow the steps in
After working inside your Embedded Box
Compliance home page at www.dell.com/regulatory_compliance.
Topics:
•
Procedure
•
Post-requisites
Procedure
NOTE:
Remove the
riser card
tweezers, or screwdriver to modify the DIP switch settings.
NOTE:
Depending on whether you are replacing PCIe(x8) riser card or any other riser cards, ensure that the DIP switch
settings are as shown in the following table.
Table 1. DIP switch settings
SW1
1
2
72
Replacing the riser card
Before working inside your Embedded Box
to modify the DIP switch settings on the CPU board. You can use a plastic scribe, pair of
2 x PCIe(x8) card
OFF
ON
Replacing the riser card
PC. After working inside your Embedded Box PC,
PC. For more safety best practices, see the Regulatory
Other riser cards
OFF
OFF
42