Bios Setup Program; Entering Bios Setup Program; Clearing Forgotten Passwords - Dell 5000 Service Manual

Embedded box pc

Hide thumbs Also See for 5000:

Table of Contents

Before turning on the Embedded Box PC, connect the keyboard, mouse, and monitor to the Embedded Box PC, or connect the

Embedded Box PC through the KVM session or use Dell Wyse Cloud Client Manager (CCM) or Dell Command | Monitor (DCM) to update

the BIOS configuration.

1. Turn on (or restart) the Embedded Box PC.

2. During POST, when the DELL logo is displayed, watch for the F2 prompt to appear, and then press F2 immediately.

NOTE:

The F2 prompt indicates that the keyboard is initialized. This prompt can appear very quickly, so you must

watch for it, and then press F2. If you press F2 before the F2 prompt, this keystroke is lost. If you wait too long and

the operating system logo appears, continue to wait until you see the desktop. Then, restart the Embedded Box PC

and try again.

NOTE:

The Embedded Box PC must be disconnected from the electrical outlet to clear the password setting.

1. Follow step 1 to step 6 in

"Removing the back

2. Locate the password reset jumper (PWD) on the system board. See

3. Move the jumper plug from pins 1 and 2 to 2 and 3.

4. Follow step 2 to step 9 in

"Replacing the back

5. Turn on the Embedded Box PC, and wait until the message stating that the password has been cleared appears.

6. Shut down the Embedded Box PC.

7. Move the jumper plug from pins 2 and 3 and replace it on pins 1 and 2.

BIOS setup program

cover".

"System-board

cover".

components".

Table of Contents