NOTE:
Before working inside your Embedded Box PC, read the safety information that shipped with your Embedded Box
PC and follow the steps in
follow the steps in
After working inside your Embedded Box
Compliance home page at www.dell.com/regulatory_compliance.
Topics:
•
Procedure
•
Post-requisites
Procedure
1. Replace the screw that secures the intrusion switch to the chassis.
2. Route the intrusion-switch cable through the routing guides on the chassis and under the heat sink pipe.
3. Connect the intrusion-switch cable to the intrusion-switch connector on the system board.
Post-requisites
1. Replace the
PCI/PCIe card
2. Follow step 2 to step 8 in
"Replacing the back
64
Replacing the intrusion switch
Replacing the intrusion switch
Before working inside your Embedded Box
(if necessary).
cover".
PC. After working inside your Embedded Box PC,
PC. For more safety best practices, see the Regulatory
36