Calibration Process - Keysight U1190A Series Service Manual

Calibration Process

1 Prior to performing the verification tests, see
2 Perform the functional tests to verify the following measurement functionality
3 Perform the verification tests to characterize the clamp meter; see
4 Prior to performing the adjustments, see
5 Perform the adjustment procedure; see
6 Ensure that the clamp meter is not in the adjustment mode and is turned off;
Keysight U1190A Series Service Guide
page 24.
of the clamp meter; see
"Performance Verification Tests"
page 34.
see "Exiting the adjustment mode"
"Functional Tests" on page 25.
on page 31.
"Adjustment considerations"
"Adjustment procedure"
on page 40.
Calibration Procedures
"Test Considerations"
on page 35.
1
on
on
23