Festo CPX-FB38 Electronic Manual page 22

1. Installation
Installation
1−6
Please note
Always use the correct screws for the manifold base, which
depend on whether the base is made of metal or plastic:
for plastic manifold bases: thread−cutting screws
Ffor metal manifold bases: screws with metric thread.
Both types of screws are enclosed respectively when ordering
the bus node as a single part.
Install the bus node as follows:
1. Check seal and seal surfaces
2. Place the bus node in the manifold base. Make sure that
the grooves (with the bus node power contact terminals)
on the bottom of the bus node are above the contact rails.
3. Push the bus node carefully and without tilting as far as
possible into the manifold base.
4. Tighten the screws at first only by hand. Place the screws
so that the self−cutting threads can be used.
5. Tighten the screws with a TORX screwdriver size T10 with
torque 0.9 1.1 Nm.
Festo P.BE−CPX−FB38−EN en 0804NH