Festo CPX-FB38 Electronic Manual page 21

1. Installation
Dismantling
1
CPX bus node
2
Manifold base
3
Contact rails
4
TORX T10 screws
Fig. 1/2: Dismantling/installing the bus node
Festo P.BE−CPX−FB38−EN en 0804NH
Please note
Use protective caps or blanking plugs to seal unused
connections. You will then comply with protection class
IP65/IP67 (see section 1.4).
Dismantling and fitting
When installed, the bus node is located in a manifold sub−
base of the CPX terminal (see Fig. 1/2).
Dismantle the bus node as follows:
1. Undo the four screws of the bus node with a TORX
screwdriver size T10.
2. Pull the bus node carefully and without tilting away from
the contact rails of the manifold base.
4
3
1
2
1−5