Juniper PTX3000 Quick Start Manual page 19

CAUTION:
connect the wrist strap to an approved site ESD point. See the instructions for your
site.
3. Plug one end of a UTP Category 5 Ethernet cable
management Ethernet port on the Control Board or RCB in slot CB0 (see
NOTE: The management Ethernet port is labeled HOST/ETHERNET on a Control Board. The
port is labeled MGT on an RCB.
4. Plug the other end of the cable into the network device.
5. Plug one end of another UTP Category 5 Ethernet cable into the management Ethernet port on the
Control Board or RCB in slot CB1.
6. Plug the other end of the cable into the network device.
Figure 10: Routing Engine Ethernet Cable Connector
Figure 11: Connecting to the Management Ethernet Port on the Control Board or RCB
During the initial installation before the chassis is grounded, you must
(Figure 10 on page 19 shows the connector) into the
Figure 11 on page 19).
19