Juniper PTX3000 Quick Start Manual page 35

Packet transport router

Hide thumbs Also See for PTX3000:

Table of Contents

NOTE:

After a PSM is powered on, it can take up to 60 seconds for status indicators—such as

the LEDs on the PSMs and the command output displays—to indicate that the PSMs are

functioning normally. Ignore error indicators that appear during the first 60 seconds.

NOTE:

The Routing Engine or the RCB—depending on your configuration—boots as the PSM

completes its startup sequence. If the Routing Engine or RCB finishes booting and you need to

power off the system, see Powering Off the PTX3000 in the

Hardware

Guide.

After powering on a power supply, you must wait at least 60 seconds before powering it off.

9. Verify that the OK LED on the PSM faceplate is lit steadily and that the

the PSM is correctly installed and is functioning properly.

NOTE:

If the OK LED is not light steadily, remove the PSM, repeat the cabling procedure, and

reinstall the PSM into the PTX3000.

10. On the external management device connected to the PTX3000, monitor the startup process to verify

that the system has booted properly.

11. Repeat Step

and Step

for the other PSMs.

PTX3000 Packet Transport Router

LED is off, indicating that

Table of Contents