Juniper PTX3000 Quick Start Manual page 21

5. Using a number 1 Phillips (+) screwdriver, loosen the two inner captive screws on the upper or lower
cable management system. Move the cover of the upper cable management system up
(Figure 14 on page 22). Move the cover of the lower cable management system down
(Figure 15 on page 22).
6. Arrange the cable in the cable management system to prevent it from dislodging or developing stress
points (Figure 16 on page
to the floor.
CAUTION:
smaller than a few inches in diameter can damage the cable and cause problems that
are difficult to diagnose.
CAUTION:
fastened loops of cable to dangle, which stresses the cable at the fastening point.
7. Move the cover of the upper cable management system down, and secure the two inner captive screws
on the upper cable management system by using a number 1 Phillips (+) screwdriver. Move the cover
of the lower cable management system up, and secure the two inner captive screws on the lower cable
management system by using the screwdriver.
Figure 12: Connecting PIC Cables
23). Secure the cable so that it is not supporting its own weight as it hangs
Avoid bending fiber-optic cable beyond its minimum bend radius. An arc
Do not let fiber-optic cable hang free from the connector. Do not allow
21