External Applications; Empty Sensor; Early Warning Counter; Peak Load Signal - Miele PWM 908 Operating And Installation Instructions

External applications

Empty sensor

External hardware is connected via the
Miele XCI Box.
A siphon contact can be used to de-
tect whether external detergent con-
tainers are empty. A message appears
if a container is empty.
– Off (factory default)
– Normally open contact
The siphons are equipped with a nor-
mally open contact.
– Normally closed contact
The siphons are equipped with a nor-
mally closed contact.

Early warning counter

External hardware is connected via the
Miele XCI Box.
An internal counter reports when an
external dispenser container is almost
empty. The counter in question then
has to be reset.
Supervisor level

Peak load signal

External hardware is connected via the
Miele XCI Box.
The peak-load negotiation function
enables the washing machine to be
connected to an energy management
system. When a signal is registered,
the washing machine's heater is
switched off for a short period.
The washing machine may only be op-
erated with a peak-load system if this
system is connected to the washing
machine via the Miele XCI box.
– No function (factory default)
– Peak load with 230 V
– Peak load with 0 V

Peak load prevention

The peak-load negotiation function
can be deactivated with disinfection
programs. When a signal is registered,
the washing machine's heater is not
switched off.
Factory default: Off
89