Installation Surface; Removing The Shipping Struts - Miele PWM 908 Operating And Installation Instructions

Hide thumbs Also See for PWM 908:

Table of Contents

Installation and connection

Installation surface

A concrete floor is the most suitable in-

stallation surface for this machine. It is

far less prone to vibration during the

spin cycle than wooden floorboards or

a carpeted surface.

 The machine must be level and se-

curely positioned.

 To avoid vibrations during spinning,

the machine should not be installed

on soft floor coverings.

If installing on a wooden joist floor:

 Install the machine on a plywood

base (at least 2' 3 9/16" x 1' 11 5/8" x

1 3/16" (70 x 60 x 3 cm)). The base

should span several joists and be

bolted to the joists and not only to the

floorboards.

Tip: If possible, install the machine in a

corner of the room. This is usually the

most stable part of the floor.

 Remove the left and right caps.

1. Pull on the secured cap stoppers

2. and use a screwdriver to release the

catches at the top and bottom.

 Using the wrench supplied, turn the

left-hand shipping strut 90°.

Table of Contents