Satel INT-SCR-BL Manual page 5

INT-SCR-BL
Authorization control [Unauth. event] – opening the door without entering a password from the
keypad (e.g. with the key) will generate an „Unauthorized door opening" event, it can also be
signaled on the output type 93
Alarm on unauth. access [Unauth. alarm] – when the partition to which the module is assigned is
armed, unauthorized opening of the door will trigger the alarm and can be additionally signaled on
the output type 94
Max. door open time – the time after expiry of which the module will report the „Long opened door"
event to the control panel and activate the audible alarm. The duration can be set from 0 to 255
seconds.
Dependent on door 1 / Dependent on door 2) – the door which must be closed for the lock to
operate. Monitoring of the door state is effected through the input in the code lock, partition
keypad, or CA-64 SR expander of proximity card readers, or through the control panel zone type
–
57
TECHNICAL DOOR OPEN
a „sluice" type passage.
Code+* do not disarm [Code
pressing the
from being opened).
Access when armed [Code
pressing the key will not disarm the partition, but it will activate the relay (and enable opening
of the door). The option is available when the
enabled.
Master users / Users – this function defines master users / users authorized to use the given
keypad.
Alarms
FIRE alarm – holding down the
AUX. alarm – holding down the
PANIC alarm – holding down the
Silent PANIC alarm – with this option selected, triggering the panic alarm from the keypad will not
set off the loud signaling; instead, a message will be sent to the monitoring station (it can also
be signaled on the output type 12
Alarm 3 incorrect codes [3 wrong codes] – entering a code unknown to the control panel three
times triggers alarm.
Options
Quick arming – quick arming of the partition:
– fully armed mode – press in turn the
with any firmware version) or the
version 1.05);
– fully armed mode plus bypassing zones with
turn the and
– armed without internal – after pressing in turn the
with firmware version 1.05 or later);
– armed without internal and delayed – after pressing in turn the
control panel with firmware version 1.05 or later).
Control BI output – the keypad accepts the
Control MONO output – the keypad accepts the
Partition blocking – entering the guard code when the partition is armed will temporarily bypass
the partition.
U
NAUTHORIZED ACCESS
A – U
LARM NAUTHORIZED ACCESS
. Two dependent doors can be selected. The function allows to create
n. disarm] – with this option enabled, entering the code, confirmed by
*
key will neither disarm the partition nor activate the relay (will prevent the door
in arm] – with this option enabled, entering the code, confirmed by
*
key triggers the fire alarm.
key triggers the medical alarm.
key triggers the
SILENT ALARM
( (
keys INTEGRA control panel with firmware version1.06)
SATEL
.
.
C +*
ODE DO NOT DISARM
PANIC
alarm.
).
and (keys (CA-64 and INTEGRA control panels
and keys (INTEGRA control panel with firmware
B
YPASSED IF NO EXIT
and
BI
type of codes.
OUTPUTS
MONO
OUTPUTS
[Code* n. disarm] is
option enabled - press in
keys (INTEGRA control panel
and keys (INTEGRA
type of codes.
5