Starting The Keypad - Satel INT-SCR-BL Manual

INT-SCR-BL
5. Press in turn the
function has been launched, and the LED designated
6. Set the address within the range from 0 to 31, using suitable numerical keys and confirming your
selection with the
address has been set. The LEDs designated
alternately (then, to proceed to setting the operating mode, press in turn the
7. Turn off power supply.
8. Connect the green and black cables correctly to the expander bus terminals on the control panel
mainboard.
3.2 Changing the operating mode
1. Turn off the keypad power supply.
2. Disconnect the green and black cables from the expander bus terminals.
3. Short together the ends of the green and black cables.
4. Turn on the keypad supply. The keypad will generate 4 short beeps and 1 long beep, and the
LEDs designated
and black cables can then be separated).
5. Press in turn the
selection function has been launched, and the LED designated
6. Select the operating mode by pressing in turn::
and – partition keypad with proximity card reader (INT-SCR)
and – entry keypad (INT-ENT)
and – partition keypad (INT-S/SK)
The keypad will confirm with 4 short beeps and 1 long beep that the operating mode has been
selected. The LEDs designated
proceed to setting the address, press in turn the
7. Turn off power supply.
8. Connect the green and black cables correctly to the expander bus terminals on the control panel
mainboard.

4. Starting the Keypad

1. Switch on the alarm system power supply.
2. Conduct identification of a new device in the alarm system. Call the
S
function (
ERVICE MODE
Note: During the identification process, the control panel saves in the module memory a special
(16-bit) number, used for checking the module presence in the system. Replacement of the
module with another one (even having the same address) without a new identification, will
result in triggering the alarm (module tamper – verification error).
3. After identification, the keypad will be supported by the alarm control panel, however most options
and functions will be disabled. For example, the lack of key press confirmation will make an
impression that the keypad does not react to entering the code. Using the LCD keypad or the
D X / D
LOAD LOAD
program functions and options of the device.
4. Terminate the service mode or communication with the computer and save the data to FLASH
memory.
and keys. The keypad will confirm with 2 short beeps that the address setting
. key. The keypad will confirm with 4 short beeps and 1 long beep that the
[ ] and
ALARM
and keys. The keypad will confirm with 2 short beeps that the operating mode
[
ALARM
S
TRUCTURE
64
program, assign the users, who will be authorized to use the keypad and
SATEL
[
ALARM
[ ] and
ALARM
[ ] will start blinking alternately (the ends of green
ARMED
] and [
ARMED
and ).
H
) from the LCD keypad.
ARDWARE
] will start blinking.
[ ] will start blinking
ARMED
and
[ ] will start blinking.
ARMED
will start blinking alternately (then, to
E
XPANDER IDENTIFICATION
3
keys).