Operation In The Partition Keypad Mode - Satel INT-SCR-BL Manual

4

5. Operation in the Partition Keypad Mode

The LEDs show following information:
red color) – steady light indicates an alarm in the keypad controlled partition, while
ALARM
blinking indicates that an alarm was triggered in the partition (alarm memory). The LED goes
off when alarm is cleared.
(green color) – steady light indicates that the partition to which the keypad is assigned
ARMED
has been armed. Blinking indicates countdown of the exit delay.
(yellow color) – blinking indicates that a technical problem has occurred. The
TRPUBLE
signaling applies to troubles from the entire alarm system, not only from the keypad controlled
partition. The type of trouble can be checked on the LCD keypad. Arming the keypad
controlled partition will disable the trouble signaling. Disarming the partition will restore the
trouble signaling.
Note: All LEDs may be OFF in the arming mode, depending on the control panel settings.
Informacje dotyczące użytkowania klawiatury strefowej znajdują się w instrukcji użytkownika central
alarmowych.
The partition keypad can be programmed by means of the LCD keypad (
S H
TRUCTURE ARDWARE
D X D 64
the /
LOAD LOAD
Abbreviations from the LCD keypad display are shown at some of the functions.
Name – option to give an individual (16-character) name to the module. This option can be accessed
in the LCD keypad as follows:
N
expander selection.
AMES
Partition – assignment of the keypad to a partition selected from the list. The keypad controls this
partition.
Lock feature – the option available in the LCD keypad – its activation provides access to the Lock
submenu.
D X
Lock ( )/ Lock feature (
LOAD
The options "Lock feature" (LCD / DLOAD64) and "Lock" (DLOADX) refer to support of the
actuating device (e.g. electromagnetic door lock) by means of the partition keypad. This
function is made available to any user authorized to use the keypad (see:
function). Control is effected by means of the relay.
D
Lock features (
LOAD
ON if partition armed – relay is active when the partition is armed (bistable operation).
Note: When operating in this mode the relay will change its state automatically, if the partition
is disarmed from the given keypad. When the partition is disarmed from another keypad,
the state of the relay will change on entering the CODE and pressing the
given partition keypad.
Fixed ON time [ON time] – the relay gets activated for the time period entered in the
function after entering the code (monostable operation).
TIME
Fixed ON time – OFF if door open [ON, open off] – the relay is activated after entering the code
and stay active until the door is opened (the door status control input disconnected from the
common ground), but not longer than for the
Fixed ON time – OFF if door closed [ON, close off] – the relay is activated after entering the
code and stay active until the door is open (the door status control input cut off from the
common ground) and its normal operating mode is restored on closing the door (reconnection of
the IN input to common ground), but not longer than for the
Relay ON time – the time period during which the relay is active. Duration of the „relay ON time" can
be from 1 to 255 seconds.
E
XPANDERS
program. Described below are settings and options available for programming
S
ERVICE MODE
D 64
) – its activation provides access to the lock feature options.
LOAD
X D 64
)/ Lock ( )
LOAD
SATEL
S
expander selection) or a computer with
ETTINGS
S
TRUCTURE
ON
.
RELAY TIME
RELAY
INT-SCR-BL
S
ERVICE MODE
H E
ARDWARE XPANDERS
M
ASTER USERS
key on the
R
ELAY
ON
.
TIME
/ U
SERS
ON