Drop Cable Connection For Line B Modules - Toshiba V Series Operation Manual

Chapter 4 Installation and Wiring

4.3 Drop Cable Connection for Line B Modules

4
52
• Do not connect the 10BASE-T or other interface to the modular connector by mistake. Oth-
erwise, it may cause not only product trouble but also smoke and a fire.
Use the following combinations of modules in an Ethernet system of dual transmission
line configuration.
• 10BASE5: EN621 (main module) + EB621 (line-B module)
• 10BASE2: EN641 (main module) + EB641 (line-B module)
Connect a main module to a line B module with a twisted pair cable. Do not combine
modules other than specified above.
(1) Connect a twisted pair cable to the line-B module drop cable connector (CN1) on the
line-B module. The twisted pair cable connector is an 8P modular connector.
(2) Connect the twisted pair cable from the line-B module to the line-B module drop
cable connector (CN1) on the main module.
(3) Insert the module connector fully till it clicks and check that the connector has been
locked.
Drop cable for
line-B module
･
Standard: 70 mm
･
Maximum: 3 m
Figure 4-7 Line-B Module Drop Cable Connection
Warning
EN6 module
or
EB6 module
Drop cable connector
for line-B module
(CN1)
model 2000 Ethernet Module Operation Manual