Toshiba V Series Operation Manual page 43

(14)After registering the above, confirm that the network information of the corresponding
Ethernet module can be read from the serial communication port (TOOL).
Start the configuration editor [Hardware configuration] for controller A to open the
screen which shows the registered hardware configuration for controller A. Then
select EN641 and execute [Edit (E)] [Parameter setting (P)] to open the following
screen.
(15)When [Tool and Card] is clicked, the network information that the Ethernet module
has is displayed from the serial communication port (TOOL).
6F8C0879
3.2 Network Parameter Setting
31
3