Toshiba V Series Operation Manual page 50

Chapter 3 Setting
3
38
(9) Confirm the current setting of EN6 module.
First, connect the Engineering Tool 2 to the serial communication port of the EN6
module (TOOL) and take out the setting. Set the transmission parameter from [Tool
(T)][comm param (P)] of the product tree. In this case, confirm the setting using the
serial communication port.
Com. Method: RS-232C, Port: COM1 (specify COM1 (in this case) as the port to
use),Timeout (s): 5.
Ethernet, Timeout (s): 3, Local Station Settings: Single (free mode), IP Address:
172.16.64.1. Then, press [OK] button.
model 2000 Ethernet Module Operation Manual