Setting - Toshiba V Series Operation Manual

• For safety, be sure to check that the base unit has been switched off before installing EN6
modules in it or removing them from it.
• For safety, do not touch the insides of the product except for the switches.
• For safety, do not disassemble the product.
• The static charged in the human body may cause the product to fail. Discharge the static
from the human body before setting the switches.
• In setting the switches, spread the electroconductive bag which contained the product or an
electroconductive mat, and place the product on it. Failure to observe this will damage the
product by the static.
• A strong force or other stress to the insides of the products may cause trouble. In setting the
switches, be careful not to touch the parts other than the switches with the tools or the like.
• In setting the switches, do not change other than the necessary settings. The wrong setting
will prevent the product from normal operation.
• Be sure to set an IP address type and a host ID.
• If the network parameters are downloaded to the EN6 module, be sure to restart it. The
parameters will not be valid unless it is restarted.
• Verify transmission at the application level using the transmission protocol.
• Do not use reserved ports No.10000 and 48000 in user application software. Use ports No.
1024 to No.65535 for user applications except for the reserved ports.
• If you have any question, contact the Toshiba service office concerned.
6F8C0879
Chapter 3 Setting
Warning
Caution
13