Switch Setting; Switch Setting Procedures - Toshiba V Series Operation Manual

Chapter 3 Setting

3.1 Switch Setting

3
3.1.1

Switch Setting Procedures

14
Before installing EN6 modules in the base unit, set the switches which determine an EN6
module operation mode and host ID. These switches are inside the EN6 module.
The switch setting procedures are described below. Figure 3-3 shows the locations of
the switches.
The EN6 module has the switches inside, so the switch cover on the right side panel (see
figure 3-1) must be removed before setting these switches.
To set the switches, follow the steps in the following sequence.
(1) Pull the cover in the right side panel by the top (triangle mark).
(2) Remove the switch cover from the product.
(3) Set the switches.
Carefully read the section 3.2 Network Parameter Setting.
(4) Place the removed switch cover back on the product.
Fasten the cover with the screw, using a screwdriver that fits the screw as when
removing it. Be careful not to overtighten the screw. Overtightening may damage the
screw threads, causing the screw to turn freely.
(1) (2)
In the case of EN651, EN661.
(1) (2)
Figure 3-1 Switch Setting Method
(3)
(3)
model 2000 Ethernet Module Operation Manual