Vecow SPC-5000 User Manual page 23

2.2.1.9 Remote Power On/Off Switch and Ignition Control
It is a 3-pin power-on/power-off switch through Phoenix Contact terminal block.
You could turn on or off the system power by using this contact. This terminal
block supports dual function on soft power-on/power-off (instant off or delay
four seconds), and suspend mode. Another function is provided ignition power
control feature for in-vehicle applications. The built-in MCU monitors the ignition
signal and turns on/off the system according to pre-defined on/off delay period.
2.2.2 SPC-5200 Front I/O & Functions
In Vecow's SPC-5200 series family, all I/O connectors are located on the front
panel. Most of the general connections to the computer device, such as audio,
USB3.1, DVI-D, LAN Jack, and DisplayPort, are placed on the front panel.
2.2.2.1 Reset Tact Switch
It is a hardware reset switch. Use this switch to reset the system without power
off the system. Press the Reset Switch for a few seconds, then reset will be
enabled.
©Vecow SPC-5000 User Manual
LAN LAN
1 2 3
LAN LAN
DVI
IGN On | Off
Pin No.
1
2
3
DVI DP
On | Off
IGN
GETTING TO KNOW YOUR SPC-5000
DP
Definition
Ignition (IGN)
SW+
SW-
PoE
LAN
DIO
Isolated
16