Appendix C Pmod™ And Stmod+ Schematic Table - ST STM32F7308-DK User Manual

UM2469
Appendix C
The Table 18
shows which signal is shared with other board connectors (such as Pmod™ or Arduino Uno
V3). A switch controlled by software is present to select which function is used (using PI10
and PH15 PIOs). Analog signals are in brackets [xxx]. The I
Arduino Uno V3 connectors. It is recommended to check the device slave address when
adding it to the bus. Refer to the following list of acronyms before reading the
•
RTS7 stands for USART7_RTS
•
ADC2.4 stands for ADC_2_IN4
•
T8.4 stands for TIM_8_CH4
•
MOSI5 stands for SPI_5_MOSI
Pmod™ and STMod+ schematic table
gives the description of the signals available on the STMod+ connector. It also
UM2469 Rev 1
Pmod™ and STMod+ schematic table
2
C bus is shared with the
Table 18:
51/59
58