Siemens RDG100KN Basic Documentation page 127

RDG16..KN
Power supply
Outputs
Note!
STOP
Inputs
Siemens
Building Technologies
Rated voltage
DC 24 V: Make sure to connect G to + and G0 to -
Frequency
Power consumption
No internal fuse!
External preliminary protection with max. C 10 A circuit breaker
required in all cases.
Q1/Q2/Q3/L-N (relay)
Use for 3-speed fan control
Rating min, max resistive (inductive)
Do NOT connect fans in parallel!
Connect one fan directly, for additional fans, one relay for each speed.
Use for actuator control (Q1, Q2)
Q1 - rating min, max resistive/inductive
Q2 - rating min, max resistive/inductive
Max total load current Q 1+Q 2(+ Q 3)
Use for external equipment (Q1, Q2, Q3)
Rating min, max resistive/inductive Qx
Max total load current Q 1+Q 2+ Q 3
No internal fuse!
External preliminary protection with max. C 10 A circuit breaker in the supply line
required under all circumstances.
ECM fan control Y50-G0
Actuator control Y10-G0/Y20-G0 (G)
Multifunctional inputs
X1-M/X2-M
Temperature sensor input
Type
Temperature range
Cable length
Digital input
Operating action
Contact sensing
Parallel connection of several
thermostats for one switch
D1-GND
Operating action
Contact sensing
Parallel connection of several
thermostats for one switch
Function of inputs
External room temperature sensor, heating/cooling
changeover sensor, operating mode switchover
contact, Dewpoint monitor contact, enable electric
heater contact, fault contact, monitoring input,
supply air temperature, presence function
RDG100KN, RDG160KN, RDG165KN Basic Documentation
AC 24 V
DC 24 V
50/60 Hz
Max. 2 VA/2 W
AC 24...230 V
5 mA...5(4) A
5 mA...1 A
5 mA...5(4) A
5 A
5 mA...1 A
2 A
SELV DC 0...10 V,
Max. ±5 mA
SELV DC 0...10 V,
Max. ±1 mA
SELV
QAH11.1 (NTC)
0...49 °C
Max. 80 m
|
Selectable (NO/NC)
DC 0...5 V, max. 5 mA
Max. 20 thermostats per
switch
Selectable (NO/NC)
DC 6...15 V, 3...6 mA
Max. 20 thermostats per
switch
Selectable
X1: P38
X2: P40
D1: P42
127 / 132
CE1P3191en
2018-07-03