Operation - Siemens RDG100KN Basic Documentation

Layout
Button operation
Siemens
Building Technologies
4.3

Operation

See also Operating Instructions B3191 [2] enclosed with the thermostat.
1
3
User action
Normal operation
Press any button
(thermostat in normal operation)
Press left button
Press left button (P01 = 2)
Press left button while "Operating
mode" via bus is Economy or while
operating mode switchover contact is
activated
Keep left button pressed and
turn rotary knob clockwise/counter-
clockwise
Press right button >3 seconds
Press right button for fan coil unit
Press right button if P52 = 0 (fan dis-
abled, e.g. in chilled ceiling applica-
tions)
Turn rotary knob
Hold down both the left and right
buttons simultaneously for 4 seconds.
Release them, and hold the right
button again within 2 seconds until
P01 displays
Press left and right button for 4
seconds, release, press left button for
2 seconds until the temperature
disappears, then turn rotary knob
counterclockwise min. ½ revolution
Press left and right button simultane-
ously for 6 seconds
RDG100KN, RDG160KN, RDG165KN Basic Documentation
1. Operating mode button/Esc
2
2. Fan mode button/Ok
3. Rotary knob to adjust setpoints and
parameters
Effect, description
Actual operating mode and state are
indicated by symbols.
Enter operating mode selection;
backlit LCD turns on, all possible mode
symbols turn on, indicator element (arrow)
will appear on the current mode/state.
Change operating mode (indicator element
(arrow) changes to the next mode symbol.
After the last press and a timeout of 3
seconds, the newly selected mode is
confirmed, the other elements disappear.
After a timeout of 20 seconds, the LCD
backlight turns off.
Toggle between heating and cooling.
Activate "Extend Comfort mode"
(for details, see page 19).
Activate timer "Extend presence"/"Extend
absence" and set the time (for details, see
page 19).
Activate/deactivate button lock.
Change fan mode.
Set thermostat to Protection mode.
Adjust the room temperature Comfort
setpoint.
Enter parameter setting mode "Service
level".
Enter parameter setting mode "Expert
level", diagnostics and test.
Enter (KNX) programming mode.
103 / 132
CE1P3191en
2018-07-03