SATO CG2 Series Quick Manual page 4

Do not place in areas with high humidity
Do not place the printer in
•
areas with high humidity or
where condensation forms. If
condensation forms,
immediately turn off the power
switch and do not use the
printer until it dries. Using the
printer while condensation is on
it could result in electric shock.
Carrying the Printer
When moving the printer,
•
always unplug the power cord
from the outlet and check to
make sure all external wires
are disconnected before
moving it. Moving the printer
with the wires still connected
could damage the cords or
connecting wires and result in a
fire or electrical shock.
Do not carry the printer with
•
paper loaded in it. The paper
could fall out and cause an
injury.
When setting the printer on the
•
floor or a stand, make sure not
to get your fingers or hands
pinched under the printer feet.
Power supply
Do not operate the power
•
switch or plug in/unplug the
power cord with wet hands.
Doing so could result in electric
shock.
(1)
Reproduction in any manner of all or part of this document is prohibited.
(2) The contents of this document may be changed without prior notice.
(3)
Great care has been taken in the preparation of this document, but if any problems, mistakes, or
omission are found, please contact the store or dealer where you purchased the printer.
II
CG208i̲E̲00.indd II CG208i̲E̲00.indd II
Caution
Power cord
Keep the power cord away from
•
hot devices. Getting the power
cord close to hot devices could
cause the cord's covering to
melt and cause a fire or
electrical shock.
When unplugging the power
•
cord from the outlet, be sure to
hold it by the plug. Pulling it by
the cord could expose or break
the core wires and cause a fire
or electric shock.
The power cord set that comes
•
with the printer is especially
made for this printer. Do not
use it with any other electrical
devices.
Top cover
Be careful not to get your
•
fingers pinched when opening
or closing the top cover.
Also be careful the top cover
does not slip off and drop.
Print head
The print head is hot after
•
printing. Be careful not to get
burned when replacing paper
or cleaning immediately after
printing.
Touching the edge of the
•
print head with bare hands
could result in injury. Be careful
not to become injured when
replacing paper or cleaning.
The customer should not
•
replace the print head.
Doing so could result in injury,
burns, or electric shock.
Caution
Loading paper
When loading roll paper, be
•
careful not to get your fingers
pinched between the paper roll
and the supply unit.
When not using the printer
for a long time
When not using the printer for a
•
long time, unplug the power
cord from the outlet to maintain
safety.
During maintenance and cleaning
When maintaining and cleaning
•
the printer, unplug the power
cord from the outlet to maintain
safety.
2008/05/14 10:07:37 2008/05/14 10:07:37