6
When the printer is offl ine, the ON LINE
(POWER) lamp blinks. Press the FEED/
LINE button 1. The printer is online and
the ON LINE (POWER) lamp lights.
When the printer is ready, press the
FEED/LINE button to output the top part
of the paper.
ON LINE (POWER) lamp
ON LINE (POWER) lamp
CAUTION
CAUTION
•
After printing, the print head and surrounding area are hot. Be careful not to get
burned when replacing paper immediately after printing.
•
Touching the edge of the print head with bare hands could result in an injury.
•
The cutter is sharp. Be careful not to cut your hands.
•
Be careful not to get your fi ngers pinched while closing the top cover.
▲ Adjusting the label dispensing stop position
Normally, the label is dispensed to the point where 2 or 3 mm of the label remain
on the backing paper. If the label is not dispensed at the regular position, use
the Phillips tip of the potentiometer adjustment screwdriver attached to the side
of the paper holder to adjust the potentiometer for the label dispensing stop
position located at the bottom right of the front panel. After adjusting the stop
position, dispense two or three labels to fi x the stop position.
Potentiometer adjustment
screwdriver
14
CG208i̲E̲02.indd 14
CG208i̲E̲02.indd 14
For label dispensing stop position adjustment
Turn left: The stop position moves in the opposite
direction of the printing direction.
Turn right: The stop position moves in the same
direction as the printing direction.
①
①
2008/05/14 10:09:18
2008/05/14 10:09:18