4
After pulling out the paper, pass the
paper through the paper sensor.
When using a cutter type, place the
leading edge of the paper on top of the
platen roller.
Paper sensor
Paper sensor
5
Close the top cover.
Press the top cover from above in the
direction of the arrows until it clicks into
position.
6
When the printer is offl ine, the ON LINE
(POWER) lamp blinks. Press the FEED/
LINE button 1. The printer is online and
the ON LINE (POWER) lamp lights.
When the printer is ready, press the
FEED/LINE button to output the top part
of the paper.
ON LINE (POWER) lamp
ON LINE (POWER) lamp
CAUTION
CAUTION
•
After printing, the print head and surrounding area are hot. Be careful not to get
burned when replacing paper immediately after printing.
•
Touching the edge of the print head with bare hands could result in an injury.
•
The cutter is sharp. Be careful not to cut your hands.
•
Be careful not to get your fi ngers pinched while closing the top cover.
CG208i̲E̲02.indd 9
CG208i̲E̲02.indd 9
①
①
9
2008/05/14 10:08:49
2008/05/14 10:08:49